Wobbly bars and forks?

[timmyyyrox2]

I just got the new Tilt scs, and I installed it but now my bars and fork wobble a little bit in the head tube. It was a little wobbly before I got the scs, but it's a lot worse now. Any suggestions?

 

[Chris Vincent]

Did you set it up right? Did you fully tighten it? If so, it may be time for a new headset.

 

[Jimmy C]

headsets loose

 

[timmyyyrox2]

Yeah, I watched a video to make sure I set it up right, and it's tight. But I still have the stock headset from my old scooter, haha. I thought that was probably it, but I just wanted to make sure. So a new headset should make things better?

 

[XXmxwebbXX]

Go and get a new headset for your scooter!

 

[gjdadj]

maybe youre forks are a tiny bit too tall, when i first got my scs the gat between the lip in the clamp and the topf my fork was about 1 cm, and when i tightened it all the way, the same thing happened, it compacts quite alot when you tighten it

 

[Rob.]

Could be many things.
What kind of fork is it?
do your bars have slits?
did you tighten the headset before the bolts?

 

[timmyyyrox2]

I have stock fuzion elite forks, and I cut the slits off of my bars. Sorry for the dumb question, but what do you mean tighten the headset? I thought only threaded headsets could be tightened.

 

[Connorh333]

It means to compress the bearings together so it doesnt have play.

 

[Dewey]

do you have a sealed headset, if so try headset spacers

 

[Dom Marconi]

I bet your forktube is just too long.

 

[Tupsu]

I have stock fuzion elite forks, and I cut the slits off of my bars. Sorry for the dumb question, but what do you mean tighten the headset? I thought only threaded headsets could be tightened.

Tighten that bolt inside the SCS b4 you tighten 4 clamping bolts.

 

[DavidBryson]

somethings wrong with ur headset

 

[Rob.]

...i think the fork tube is too long and is going past where it should be in the SCS.
thats possible.

is a starnut installed in the fuzion fork?

 

[timmyyyrox2]

Oh, yeah I have a starnut in the fork, and I tightened it. I'll look at the forks length but I'm pretty sure it's not too long

 

[Trevor]

make sure the headset is fully tightened and use loctite

 

[Damianscoots]

you need to cut your fork about 1 inch down because your forks are to tall

 

[robtom123]

what headset is it?