scootin24/7
Member
just e-mail me at skating_volcom@yahoo.com , but just tell me if u are so i can log on, and if i do decide to trade then youll give me a blade brake + $50
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
WTB: bars
- Thread starter vadder99
- Start date
scootin24/7
Member
i can, what size would u want them
scootin24/7
Member
could u cut down the hight and ill cut down the width
scootin24/7
Member
ya ill sand them down, so r u going to buy them, and i fi sand them down then i might not be able to get every corner at the gussets, ill get pics up after i done
scootin24/7
Member
k i will try tom. or thursday
scootin24/7
Member
ok but im not going to cut them down until uv'e made your choice because i dont ride that narrow if u dont buy them, but if u do then ill cut them
scootin24/7
Member
ok kol, so it is the blade brake and $50, just making shure
kelbaugh18
Member
nick u should get them bars
yea and i am allowed to buy the bars my dad just wants to see a pic firstscootin24/7 said:ok kol, so it is the blade brake and $50, just making shure
mbillick1993
Member
i got bars 20 high 20 wide made by tanner esser they are raw clear coated so they dont rust if u want i could paint them it will just cost more im asking for 40$usd + shipping ill get pics up later
scootin24/7
Member
uve already made the deal, come on!!