YOUR BROKEN SCOOTER

Krzysio

Krzysio

Bronze member
10352582_738751242849846_5657385618144649725_n.jpg

Only 3 weeks - UA v1
 
A

Austin Forkner

Steel Member
l81QiXr.jpg
Had my reventon v2 for about a month and this happened. The right dropout is is bent and I think it's twisted a little to cause it bent the axle and a straight axle will barely go through.
 
V

Vito

Bronze member
v2i is not 'really' weak. Mine's been holding for more than 2 years now, although I don't grind and don't go huge stairs.
 
vohvelivaras

vohvelivaras

Member
i rode it 7 months and noticed 1cm long craks both sides of the headtube. then they started to grow and then it just snaped. i got new one for free and have ridden it allmost 2 months and its going fine :)
 
V

Vito

Bronze member
there is a thing with v2i: mine differs from my friend's and probably the standartization in general is a bit poor; the blunt plate on mine is welded a few millimeters higher then on my mate's thus making the area of this type of breaking stronger, because the bottom of the hole is higher then the level of standing surface. Oh, I explain perfectly!
--
but this doesn't apply here as in this case the blunt plate cracked in the middle (?) or got torn off the bottom
 
You must log in or register to reply here.
Top