YOUR SCOOTER

[Derek Seay]

like a district, with more hops. i still have whips, heels, dub whips & dub heels no problem. this deck is the best. hands down.




it would be too hard to tighten the axle if there were no cuts. you can still do icepicks on this one, but i might change it up a little bit to make them a little easier.

Hep, you should try and incorporate spacers into the extrusion. It was such a pain getting spacers into my flight.

 

[devinthedew2]

 

[gjdadj]

i love the look of the dropouts! i want one so bad

what is that?! the sides and bottom look amazing for grinds and whips! i want.

 

[scooterkid1018]

its a new TSI. soo sick Hep

 

[GMscoot]

Addict Grips: too long i know
Rup bars
Proto Scs
District headset
Smx v2
Benj district sig deck
2 pos wheels random bearings

Will this setup work with a BABY SCS

 

[Parker AZ]

Will this setup work with a BABY SCS

Yes

 

[Robert]

ya but you will have to use spacers

 

[Hunter Treviranus]

yep you just have to cut forks down unless you want to run spacers.

will work as long as bars are not HIC (1 3/8) meaning they are standard size tubing (1 1/4)

 

[Parker AZ]

will work as long as bars are not HIC (1 3/8) meaning they are standard size tubing (1 1/4)

He has RUP bars

 

[GMscoot]

Traded my deck, painted this one metallic copper. It's absolutely perfect to me.

What kind of forks and SCS are these

 

[Robert]

What kind of forks and SCS are these

tilt scs and looks like mgp or razor phase 2 forks

edit: or tilt

 

[Derek Seay]

They're tilt.

 

[GMscoot]

Would the following setup work without modding: district v2i deck,proto baby SCS, and SMX forx

 

[Robert]

Would the following setup work without modding: district v2i deck,proto baby SCS, and SMX forx

this is the most common asked question

no you will have to cut the forks or use spacers

 

[GMscoot]

What about Phoenix forks

 

[devinthedew2]

bump

 

[adeq98]

By adeq98 at 2012-06-01

Grips: Odi grips
Barends : Odi
Bars : Razor Ultra Pro
Clamp : Blazer SCS
Headset : FSA The Pig
Forks : Grit Mayhem
Deck : Razor Ultra Pro v2
Wheels : Cropley 100mm
Bearings : Razor
Brake : Rush Flex Brake

 

[Victor C.]

 

[Connorh333]

Everything but the deck, but nice scooter!

 

[tylerbillman]

Hep, you should try and incorporate spacers into the extrusion. It was such a pain getting spacers into my flight.

It only took me something like less than ten minutes on my Threshold but I was thinking maybe weld little spacers on, kid on like how they are on Striker forks or most other forks?