Death Click

[Sc00t3rin]

I waz wondering to to fit death click in a 125mm hep greg other than using tape before from the weight and heat on the bearings it seam so melt the tape and make a stick mess in the bearing cups....BTW i used electric tape so that might have bin the problem with it melting, also paper and the did not work so plz help me or tell me wut to do in order to spot the noise and the movement of the bearings! Thank You

 

[Michael Rankin]

i use scotch tape. it works pretty good

 

[Sc00t3rin]

i use scotch tape. it works pretty good

have u even taken the bearing out if so waz it all stick inside or waz the tape still in good condition?

 

[Michael Rankin]

you still have to replace it every once in a while. you will have to with any tape

 

[Sc00t3rin]

ight ill do that how often do u have to do it?

 

[Michael Rankin]

i did it whenever the tape wore out and started clicking again

 

[iscootscoot]

abot every 3-4 hours

 

[Sc00t3rin]

abot every 3-4 hours

o man...i scooter more than 10 hours a day!

 

[Michael Rankin]

then you will be taping quite a bit haha. are you running metal cores?

 

[Sc00t3rin]

LOL ya i do 125mm hep greg wheel and i am using it as a front wheel how do u mess these babys up??

 

[Michael Rankin]

well another trick that i tried was i hammered in the edges of the bearing slot lightly until the clicking stopped. i just had to re-do every day. but at least its easier then taking the wheels and bearings off everytime. it worked pretty damn good whenever i did it

 

[Sc00t3rin]

ya but then over along period of time it will get so messed up that i will not be ride able i am guessing that i am going to have to live with it

 

[Michael Rankin]

ive been doing the hammering trick for almost 2 months. remember you just have to lightly hit with the hammer, just enough to stop the clicking, not reshape the slot