Aus Your Scooter V.2
- Thread starter 2155
- Start date
ashz893scootys
Member
wat does the pin look like before it goes in jason?
and how did u raw the fork
and how did u raw the fork
ashz893scootys
Member
i gotta re post mine again looks better with forks and wheel
nick_is_me1
Member
Jason Elies: Scooter Docter/Expert.
James Scown
Steel Member
how the fuck do you do that
i wanna pin mine up
i wanna pin mine up
JarradSmith
Jarrad Smith (Gen Y)
Drill small holes throught the bit that fell off and the bit it attaches to and put those pins or grub screws in it is my guess.
James Scown
Steel Member
shut up, dont even try when you have no clue
Jason
Silver Member
Here's what you doooooo:
Take a scooter axle screw down to the hardware store. See if you can find 2 of these:
They may also be dark brown (like raw chromoly colour). Try and find ones shorter than an inch.
If your fork is completely pulled off, jam it back together with a vice.
Grab a drill bit slightly smaller than the pin and drill a hole in the front and back about 2mm below the crown.
Simply hammer in the pins and away you gooooo.
Take a scooter axle screw down to the hardware store. See if you can find 2 of these:
They may also be dark brown (like raw chromoly colour). Try and find ones shorter than an inch.
If your fork is completely pulled off, jam it back together with a vice.
Grab a drill bit slightly smaller than the pin and drill a hole in the front and back about 2mm below the crown.
Simply hammer in the pins and away you gooooo.
James Scown
Steel Member
thankyou
JarradSmith
Jarrad Smith (Gen Y)
Fuck up asshole. I pretty much got it right.James Scown said:
JarradSmith
Jarrad Smith (Gen Y)
For you Jas <3
matt clarke
Member
the mgp looks so good im so getitn 1
ryanlovegays
Ryan Lovegays
LOL in the bathroom
Nickeh <3
Nickeh <3
