BAD bars - Rad bar alternative

A

AX3D

Member
Wow cant wait. (I bent my stupid handle bar down but not that bad it just looks kinda messed up) I will mos likely buy them depending on the cost.
 
Madis

Madis

Super Geek
Staff member
A bit offtopic, but Cory, are you getting some new bars ready sometime?

I'm asking because due to some things like Andrew being idle starting from next week, then i should order those wheels as soon as possible, but i'm wondering if it is possible to you to make some bars (should andrew send wheels to Miles and I wait for the bars...) or not (...or should andrew send the wheels directly to me)? No matter if they would be newer prototype...
 
C

coryM

Member
uh well i have noe tubing or anything so i doubt we will make more anytime soon but alot of people are on my ass about it so i wanna make more soon. but definetly not next week. pm me or somthing and maybe i can just send some to you whenever it is we finally buy some tubing.
 
C

coryM

Member
depends on what size and lenght. you can get about 10 feet of the size the steertubes use (1.25ODx.058wall) for like 35-40$ and thats pretty cheap. i went to one place and it was 120$ for 20 feet of 7/8 and that was BS. also 7/8 is about 4-5$ per foot but the longer peices you get then it goes down a bit so 8 feet is like 25-30$.
 
J

Jo Sto

Member
my rad bars broke so i did this,,,,, went to the hard ware store and got 2 bolts tyhat fit in to the ends of the bars. wrapped them wit duct tape and put my grips over them...... it made it sturder and heaver like rads, and it made the bars about 15' wide
 
You must log in or register to reply here.
Top