Bar extender bar ends?

[Ethan_]

I know there might be a thread for this but where can i get some? I have a bike shop nearby called freeride. Im looking to wider my prys and steel trees a bit

 

[KyrinBingaman]

You could just make some with a 1/2" wooden dowel and some old bars.

 

[issac p]

the wooden dowel method sucks.
there used to be a bmx company that made some bar extender bar ends, but they dont make them anymore. your best bet is either get some machined, or welding on pieces of other bars onto the ends of your bars.

 

[Ethan_]

Took off my extenders and now my prys are 24 by 21 to 22

 

[RiccardoM]

You know the bar ends that you screw in? Slip a bearing case or two onto them and stick them on as normal.

 

[issac p]

riccardo, you mean like the outer metal piece of a bearing?

 

[MartinRowlands]

Get some odi barends (or any barends that dont have screws) Then use four outer metal rings from a bearings, put two of them on each barend, then super glue the barend's into the bars, thats what i did, worked for me.

 

[RiccardoM]

riccardo, you mean like the outer metal piece of a bearing?

Yeah. You might need to put tape around the bearings and the bar extender depending on the fit.