Blade Break wobbling

[ryan kruse]

Ok so i grinded it down and everything i needed to to get it to fit. i stretched the break and did the coin trick and i also hot glued it but the coin just fell out from impact and it wobbles. any ideas how to fix it?

 

[ben-pat-bro]

use a bearing instead
thread/

 

[ryan kruse]

It Wouldnt work cause i used 4 20c pieces and hotglue and they just fell out

 

[Michael Rankin]

i actually wrap one or 2 nickels in a good amount of electrical tape so the spring will dig into the electrical tape. i guarentee this will work 100 percent.

 

[ryan kruse]

so i wrap my coins and spring around with duct tape?

 

[Michael Rankin]

no just wrap the coins in tape. once you put it under the spring, then the spring it dig into the tape and hold it there

 

[ben-pat-bro]

i asure you if you put the bearing under the spring
and than glue, it wont fall out..

 

[nolife_like_lowlife]

i just bent the spring tighter so i hav no bearings or coins and it works great

 

[Callum Ellis]

Take ur brake out drill it to a 6mm hole then do same to deck and put a 6mm bolt though it then get ur spring in a vice and bent it to original shape so its tighter ,How To Dial A Blade Brake!!!