bolting bars

[lloyd]

I want to bolt my bars so they dont move but does it work well? and how do I do it? Is it better to make bars. cuz I cant seem to find the thread on making rads...

 

[young08]

to ur 1st question.. YES .. to ur 2nd question.. drill a whole thru and bolt it

 

[jakob-b]

theres a video on it

 

[lloyd]

is it the video how to bolt your t tube? because I ve watched it and It doesnt talk about bolting bars.

where can I find a bar that goes thru the t tube? hardware store ?

 

[Behlau]

Use a bolt that you would use to put on your front wheel that size is perfect.

 

[Eric Magray]

yea just make sure you use the right bit when you do it

 

[jerms747]

actually theres an easier way me and my friend get small bolts that jus fit and use a magnet and bolt them inside

 

[briflip]

actually theres an easier way me and my friend get small bolts that jus fit and use a magnet and bolt them inside

whatttttttttttttttttttttttttttt

 

[lloyd]

where can I find a tube to go thru the t tube instead of the bars?

 

[jerms747]

well you get little allen key bolts and nuts tht fit them and then take a magnet and hold it insede the t-tube and then screw the bolt in it

 

[blanket687]

that is confusing, but it sounds cool

 

[dre]

well you get little allen key bolts and nuts tht fit them and then take a magnet and hold it insede the t-tube and then screw the bolt in it

I bet it would be a hell of a lot easier to just put two bolts right through the holes and out the other end. Then make sure you measure and find the right size bolt, otherwise you might have to cut it off at the end and it'll be a bit sharp. Or use a locking nut with the rubber o-ring on the inside to make sure it doesn't wobble and come loose or anything...

 

[jerms747]

i made a video explainin my way

 

[DaNnYc]

yeah bolting your bars is way easier than drilling like jeremy said i was the one to do it for him here are the pics

 

[jerms747]

http://www.youtube.com/watch?v=Nojfl_T3U5E

 

[Scooter Mcgee]

Sounds like a smart idea. Video is still processing...

 

[DaNnYc]

i put the pics up in my edit above

 

[dre]

that's pretty cool. I don't have a good magnet that could all the way in through the bars, even though you could tape one to a stick or something... I'd probably just stick with bolting them right through because you can adjust it 100 times easier if it does come loose.

 

[DaNnYc]

yeah before i bolted mine i taped them and put them in so it definatly doesnt wobble then i bolted them

 

[lloyd]

OMG thanks just got it. I'm doing it now!