Eagle bearing problem, please help

[cal]

I tried to take the bearings out of my eagle fernando young and inner race of the bearings fell out and so did the ball bearings. problem is the outer race didnt and is stuck in the wheel

 

[nitroRCs]

Um. Maybe put some WD-40 on it, get a flat head screw driver and go around it and tap the screwdriver while its on the bearing race with a hammer.

This should get it out...

 

[cal]

problem is that with the outer race it is completely inline with the inner wall of the wheel! fuck

 

[Zaηe]

Happened to my mates little brother, but it was already out a bit so i could get it out with a screwdriver.
You should cut it, go to a steel mill or someplace like that and see if they can cut a slit in it.

 

[cal]

yeah will do, i could do it with a hacksaw blade ? aha

 

[Arborigeni]

Common sense man. Don't take a blade to it unless it's a semi-precision tool like a Dremel with a cut-off wheel. Use a screw driver to get it out. Put the tip of a flathead screw driver in the groove of the bearing case where the ball bearings would usually glide. Then tap it out with the wheel in a vice or in a secure spot. If that doesn't work make several small slots in the bearing race with a Dremel or a similar tool and break it apart with a flathead and a hammer.

 

[Billie Rainbow]

wtf how can you not get it out? hit it out with a flathead from the other side but in more than one spot. thats exactly how i do it to get bearings out when it has one of them piece of shit eagle spacers

 

[cal]

Nah billie, it has no spacers, whats happened is the inner bearing race fell out and so did the ball bearings, so yeah look at picture

 

[Zaηe]

So the bearing case is perfectly aligned with the inside of the wheel and has no lip for him to get a screw driver on and hit out.

 

[cal]

yeah exactly and this is a 75 dollarr wheel and its 1 week old :s

 

[nitroRCs]

U can still ger the screwdriver in there though. I had to do the same thing on my Hep Greg which is exactly the same design..

 

[tarrymonz]

that happened to my mate at the skatepark and i got it out with an allen key
but his was a plastic core
it should come out he same way bearings come out

 

[Tomm.]

Same thing happened in my lucky wheel.

How did you get it out would be much appreciated

 

[Devin Parker]

ohhhh!!!! happened to me too get a hammer and a punch. thats all ya need.

 

[Coltonscoots]

set it on top of two paint cans with the bearing hole in the middle, flathead screwdriver hammer it out. dont stop, hit it solid

 

[Dominic sanguinetti]

same thing happend to me today

FUCK EAGLE

 

[Rob.]

What a stupid bump. Maybe if you uninstalled them correctly you wouldn't be saying "FUCK EAGLE."