Ethic Fork help

[Ads88]

I have decided to make this thread because I do not want to keep asking for advice on these forks on the This or that thread. Basically I am wondering If you can run Tilt SCS normally through these forks if the ICS is not installed, or if you have to do it without the starnut in your forks.

I have searched up how to install scs without a starnut in your forks and found this video http://www.youtube.com/watch?v=P3n0U-VRls0 , He uses it with HIC, so i'm just a bit confused with how you would do that with scs.

Any advice/answers to my questions would be appreciated. Thanks

 

[Josh Henderson]

cut the top off, and then install the starnut.

 

[brody01134]

yeah you just cut off the top of the fork and install a starnut. my friend had to do it.

 

[Jordan Jasa]

i heard you could put a starnut in upside down from the bottom if you didn't want to cut it

 

[BabboonScoot]

Upside down star it doesn't work unless it has something to stop it from sliding

 

[Dallen.]

Upside down star it doesn't work unless it has something to stop it from sliding

The top if the fork

 

[RiccardoM]

If you wanted to run spacers you could stick a bolt up and through the top cap and then bolt it from there.

 

[Ads88]

Ok, I'm getting mixed responses but from what i have gathered I can run scs normally if I cut a bit off the top of my fork? So I just cut off the top cover thing with the little whole in it keeping as much of the fork as possible

 

[Garrett B]

Ok, I'm getting mixed responses but from what i have gathered I can run scs normally if I cut a bit off the top of my fork? So I just cut off the top cover thing with the little whole in it keeping as much of the fork as possible

Pick one.

A-put a starnut in from the bottom of the fork until it reaches the top and then use it just like regular scs.

B-Cut off just the top piece on the fork ( this piece doesn't allow you to insert a starnut from the top) and install a starnut, then use regular scs.

 

[Robert]

The ics bolt is huge, it probably wont work with ics/scs.

 

[Ads88]

Ok, what should I use to cut the slit off my bars and the top off my fork?

 

[Robert]

Ok, what should I use to cut the slit off my bars and the top off my fork?

A saw.

 

[Ads88]

A saw.

Sweet, Just checking a normal handsaw won't break if I cut the slit and forks with it.

 

[Dallen.]

Sweet, Just checking a normal handsaw won't break if I cut the slit and forks with it.

Hacksaw. Not a wood one

 

[dpnelson31]

i heard you could put a starnut in upside down from the bottom if you didn't want to cut it

Just do this. That is how I ride my District fork.

 

[Ads88]

Ok and last thing, Just checking I'll be able to ride 100MM wheels with an ethic deck and forks. (Don't say buy 110's because I don't have enough for them)

 

[Robert]

if its made to ride 110mm wheels, then of course you will be able to ride 100mm.

 

[Ads88]

if its made to ride 110mm wheels, then of course you will be able to ride 100mm.

Ok, sweet so I just change the axle?

 

[Robert]

Ok, sweet so I just change the axle?

no.

 

[Ads88]

Ok, keep the axle. And last thing, will a regular 1 inch starnut fit in these forks once I have cut the Ics thing off or do I need a 7/8 inch starnut?