fixed the sr fork problem...might be needed for future...

S

scooter justin 25

Member
ok

the problem was my bars were not wide enough for the fork....so what i did


i took a hacksaw and made the two gaps in the bars longer...if you look at the bottom of stock promod bars there are two seperate bases....this is because they made gaps so you could clamp down on your fork better


what i did is i made those two gaps longer...so then more of the bars could be bent to fit the fork

i then took a hammer (i dont know if a certain size is needed) and pounded it into my bars...to the point where it was pretty stuck...i then put all my weight on the bars (stepped on) and bent them outward by pushing the opposite way with the hammer...

if nebody who ordered a sr fork and has stock bar problems let me know..i can help
 
W

WayFastRevo

Member
is the fork too big?

with my friend we had to cut down the fork TUBE about a 1/2 inch.

MCooters justin said:
mark....i think it is too big...but i just dont know where...
Click to expand...

I think it is the fork tube
 
S

scooter justin 25

Member
Mark Ripoll said:
is the fork too big?

with my friend we had to cut down the fork TUBE about a 1/2 inch.

MCooters justin said:
mark....i think it is too big...but i just dont know where...
Click to expand...

I think it is the fork tube
Click to expand...



well then idk wat imma do...cuz i dont want to cut it..cuz iscoot bars are opening soon

do you know if iscoot bars work with sr forks??? cuz i can wait a bit..cuz like..winter breaks almost over and right now its snowboarding season...sooo

if i can use iscoot bars i just wanna use those???



edit 1:


also..could the fact that i really tightened my bars on my last fork be the problem?? they could be deformed...but idk??
 
S

skavenger

Member
MCooters justin said:
yes..i got the headset over the fork tube fine...
Click to expand...

well that means teh fork tubes the right size. I think its because Stock razor bars dont let the fork go into the bar far enough, because it tapers in.
 
J

Jack;

Member
skavenger...his forks to long....not to big...id jsut wait till iscoots...if those dont work then cut it
 
S

scooter justin 25

Member
well i fixed it...but

think about threaded bars and you only twist them on like..1 cm..then tightening the clamp as much you can....and not being able to twist them ne more....

excpet now imaging that on a sr fork...but not being able to slide it in...

and i will once i get my camera...

i cant find it

but the worm

do i need to since i fixed it?
 
You must log in or register to reply here.
Top