French id v2.
- Thread starter Devon Garcia
- Start date
Ostronomer
Steel Member
Ya I have a couple of these, they are legit as fuck.
Brandon Low
Streets on Lock
congrats french id.
question.. why didn't they just weld it?
question.. why didn't they just weld it?
Ostronomer
Steel Member
Aesthetics. It's beautiful. If the fork tube was wide enough I'd fuck it.
Devon Garcia
Member
CNC'd one piece French ids would be amazing.
Seth Brown
Member
looks much more professional and clean without obvious welds in my opinion, but I might be biased because I ride a French iD fork lol
kurt warren
Member
are they threaded to the legs, because that would be amazing
also, when and where r they available?
also, when and where r they available?
ScoOter_ChilLa
Member
here you can buy it : http://www.k-124house.com/KICK-SCOOTER//French-ID/HDDB4aea218b14767
are they good? i want to buy one
are they good? i want to buy one
JohanGrunwald
Member
I cracked this fork after a week! It's not better at all! They only pinned one side of the fork so it's still shit!
Also it has been on the market for a long time now. This fork is nothing new, and everybody in Europe knows that.
It's a tiny better, but not much if you can crack the legs after a week
Also it has been on the market for a long time now. This fork is nothing new, and everybody in Europe knows that.
It's a tiny better, but not much if you can crack the legs after a week
Joe Manson
Member
either that or when u weld alu it looses strength which means theyd have to heat reat it , and aparently alu welding is mad expensive and i think heat treating is expensive to, so it make the prive stupidly high Not sure tho
Gio Ghoehne
Member
nice I want those! idont care how much they just look so sick
Cody Appelhans
Member
One would have been fine, two max
Ostronomer
Steel Member
No need haha
stefan hefner
Member
wow one pin, like that can stop my wrath