headtube angle

[scootermcinnis]

for some reason my 160 pounds of force is not enough to tighten my folding mech
i have an old A headtube and it squeaks all the time i tried putting something
in the top slot above the bolt so it wouldn't slide up, well i guess that didn't work
and i tightened it more and the angle is more than a razor pro headtube for some reason
i put it up t my friends and it leans back like a mo fo, any ideas of why this is happening,
it happens even if i put the headtube as far forward as possible, its so annoying, anyone know whats up?

 

[humpurple kushiones]

make it loose, put the headtube all the way back, make it tight, the end

 

[asianpuff16]

It could be your bolts being to small
try switching with bigger bolts that is the exact size

 

[scootermcinnis]

what do u mean?

 

[Remco]

So it can not move back and forth when you put the bolts thru.

 

[Sam Carter]

yeh ur bolts r 2 small this happened 2 me jst get the right sized bolts!

 

[scootermcinnis]

they are the right size though

 

[Jon.]

idk maybe your headtube is too small loosen it up and put some metal plates it or something

 

[humpurple kushiones]

take off your sig its to fucking big. do you have problems?

 

[kurt warren]

get a bit out of where u took all the guts out of the foldy and stick it on top of where ur top bolt goes, it makes less room for the bolt to go leaving a nice slot for ur bolt to sit in whilst tightening

 

[scootermcinnis]

i did that

 

[jzf88z]

you need 2 5/16 bolts and one 3/8 bolt and use washers. see www.inward-scooters.com under boltsets.

 

[Joe Manson]

could weld it into place...

 

[humpurple kushiones]

could weld it into place...

welds crack, makes headtube weaker, shit idea