help!!

my friend stripped out two bolts on my scs and i cant get it off any ideas? it sounds loose and i dont know how to get the bolts out
 

Stackies

Steel Member
Cut em is the best thing to do, or if there not stripped too bad hammer the allen in then slowly loosen it.
 
yeah they are stripped really bad but they are so tight i couldnt even loosen it like as hard as i tried. if i cut them how do i get the pieces out?
 

j-DoGg

Steel Member
in the middle where you can see part of the bolt get the blade to a hacksaw and just saw away at it and when it is almost done the part where the allen goes will pop out then what you do is find a small pair of needle nose plyers and start untwisting it where the allen side of the bolt would be
 
use a torch to heat up the hex in the allen key which will make it expand, then use the allen key to loosen it up, it always worked for me
 
i know everyone's thinking this, is amber hot at all?
cus i just can't imagine a good as lookin chick, pullin off whips
 
Top