Homemade pegs?
- Thread starter mattyts
- Start date
Wheres that?
I make bearing pegs. Pretty much, find 5 or 6 really old shitty bearings, or new ones if your rich. Get a back axle and put it through the fork with the wheel on and all, then put the bearings on the left over axle and tighten it up. Only works on front, unless you get a really long bolt for the back.
Think this only works with stock forks to, not sure...
Think this only works with stock forks to, not sure...
zak.
Member
zak.
Member
like you can em pretty cheap for a set but im not shure if you can get them separately but the size is 1/2
i just took it out my garage cos there was more that 1 in that size , but its strong as hell !
if you made it yourself on a lathe wouldn't you have to lathe a perfect size axle on it as-well , then put thread on it ?
picture didnt work so heres the link:
http://www.hardlinescooters.com/store/index.php?main_page=product_info&cPath=12&products_id=19
http://www.hardlinescooters.com/store/index.php?main_page=product_info&cPath=12&products_id=19
zak.
Member
ah sweet
that would be good i thought you ment the ones were the peg and axel are one piece and nut goes on outher end like ( would be very hard to make on lathe_)
if you make them ,make grooves in them for speed , less surface area kinda thing
ill defo make grooves,whata great idea,ill have picturesw soonI made socketpegs yesterday, just getting the front one cut down a bit. Pics later when I get home.
Everyone told me to get a 5/16 bolt for an axle but it was to small? So I just put tape around it and it works now without wobbling.
I used 18mm sockets and a 4.5 inch bolt for the back, with two extra spacers and a lock nut, and a MGP back axle for the front. I got a bolt aswell but I'll keep that spare.
Everyone told me to get a 5/16 bolt for an axle but it was to small? So I just put tape around it and it works now without wobbling.
I used 18mm sockets and a 4.5 inch bolt for the back, with two extra spacers and a lock nut, and a MGP back axle for the front. I got a bolt aswell but I'll keep that spare.
airplanes18
Member
get crome sockets
draper 1/2
perfect after cutting a few mm of end
sliiiiiide well
thats exactly what i have.
what size are those? mine are 11/16th