how do i put bearings on?

[Ben Para]

hey im kinda new to scootering and i need some help on how to get my old bearings out without destroying them, and getting them into my new wheels thanks if you helped

 

[Mattt.C]

Allen hey and push them out.
And just put them in straight and push it onto a bench or somthing.

Also 'how do put bearing'

 

[Jarryd M]

Use an allen key, put it inside the wheel where the axle goes between the bearings, and kind of use the allen key as a lever to lift the bearing out of the bearing slot. Putting them back in; just press them in and they should go in, unless they're metalcores then you might need to use a press or a hammer or something.

Edit: Beaten to it by Matt haha

 

[Ben Para]

thanks

 

[mcnutty93]

take somethin semi long like an allen key and put it halfway in the bearings... then once it catches the bearing pound on it and itll knock the bearing out
then just push the other bearing out

to get them in you can just push em in
if that doesnt work take a bolt 2 washers and a nut nd then put 1 washer on the bolt and slid it through the bearing-wheel-bearing then slide on the other washer
put on the nut and tighten it
it should put the bearings in properly

 

[James Shaheen]

just pop um out with an allen key and if u dont wana look for a bolt i found another easy to install bearings with ur back axel. just slip on ur normal spacer for ur back axel than put on ur bearing stuff than ur other back axel, and add 2 washers to the end and tighten it up

 

[Ben Para]

thank you so much they on ))))