gorrilaman
Member
Hello , I know to bolt a t tube,you drill through the t tube and at the hole which is located at the right side (my pro model is on the right) but then how do you take out the quick release clamp ?
how do you bolt your t tube?help me?
- Thread starter gorrilaman
- Start date
1 go and get to good screws and a matching drill bit that can go threw metal
2 make sher your handlebars are low before you drill or eventuly you'll snap it.
3 drill the bit threw noth sides of the tube and then insert your screws on tight.
dont worry if your screws start to get loose they will eventually start doing that but if it does just keep screwing them back in.
2 make sher your handlebars are low before you drill or eventuly you'll snap it.
3 drill the bit threw noth sides of the tube and then insert your screws on tight.
dont worry if your screws start to get loose they will eventually start doing that but if it does just keep screwing them back in.
gorrilaman
Member
Hello,step 2 is confusing. I thought you put the handle bars at the height you like and start drilling? How do you take out the quick release clamp?
Australiano
Member
you basically drill a hole right through the side of the handlebars, with the handlebars at preffered height
then you but a bolt through. To take of the clamp juuse some pliers and like bend it :l
then you but a bolt through. To take of the clamp juuse some pliers and like bend it :l
gorrilaman I dont care if you dont want to ride them low or drill them low Im just saying that its gonna snap if you bolt it any higher.
Australiano
Member
Dude the wrench size is 5mm... No-body is saying that if you don't bolt it they will break, they're saying its better to bolt it so you don't keep hitting your knee on the quick release.
hahah, and plus everyone is going for the Rad bars look with there scooters.
Brian Boston
I got myself banned.
People were doing it before RAD bars, so you dont bust your knee on the clamp. Heres some clearer directions.brock may said:
-Keep your clamp on, and put your bars at your desired height
-Get the appropriate drill bit for the bolt your using (front wheel bolts work fine)
-Set up the tube somewhere so you can drill it properly
-Drill the hole all the way from top to bottom
-Make sure the bolt fits and goes threw
-Take your bars/clamp off
-Put the bars back in and put the bolt in, tighten
gorrilaman
Member
Hello,I don't have the tool to screw the screw off but I also didn't know what was that screw for and if it was really wasjakob-b said:
holding the clamp at the position and so I used some strenght and I pulled the shit off and then I took out the handle bars and threw away the clamp. Thanks everyone for posting your answer!