How to get out bearings.

[Eagle]

Hey my bearings aren't spinning well so I would like to replace them, unfortuanetly I cant get the damn things out any advice would be appreciated.

Thanks

 

[Kieran Mayhew]

What wheels are you running?

 

[Sebastian]

Hammer and screwdriver?

 

[Zaηe]

Have you got bearing spacers that move around inside the wheel?

 

[jacob pearcey]

put the wheel just a bit on an allen key and use the wheel like ur opening a pop can.....it works everytime

 

[Zaηe]

No it doesnt.
If the bearing spacer inside the wheel can move around freely, make it so it is blocking the hole inside the wheel. Then stick your axle into your wheel, but it wont come out the other side because the bearing spacer on the inside is blocking it. Use that to knock out your bearings.
In fact, il make a video tomorrow.

 

[Remco]

use an 6mm bolt and stick that in the bearing. Make shure it rests on the edge of the opposite bearing and start tapping it out, make circles while tapping. When you get one bearing out, remove the spacer... Then use the other end of the bolt and put that against the bearing from the inside of the wheel out. Tap the bolt till the bearing comes out.

SORTED

 

[Jacobo]

what do you do if the bearing spacer isnt moving around?

 

[Nick Griffin <3]

stick an allen in there make sure it catches the side of the bearing and hit it as hard as you can with a hammer.

 

[Jacobo]

yup i got it
i completely destroyed one bearing in the process but they were shit bearings so idgaf

 

[-Mark Kuhna]

put the wheel in a vice, then move around the bearing spacer till you have a screwdriver in there, then hit with a hammer a couple times