Cristian Castro
Member
how do i make my brake to be solid and not rattle or make noise?
how to make a scooter brake solid!
- Thread starter Cristian Castro
- Start date
michael pytel
Member
first take you spring out, second take a big pair of pliers and squeeze the spring together then put it back on your scoot, and use a Flathead screwer and lift up the spring leg thats in your deck, and put the part that is perpendicular the the decks side, and put it into the hole part of a nut.
SteveHolland
Member
put a quarter in the spring
CristobalMacias
Member
put a washer in the spring where your wheel is and i put another washer where the spring is in the deck but thats just me.
danielaurelio
Member
fakey brake, tsi deck/brake
Andy Mickey
Member
haha i was wondering if it was possible to make the brake more solid. razor brakes suck dick.
Michael Rankin
Super Moderator
did he say anything about buying a new brake? no
TUC
Member
no brakeless is da shit!
Captain.Sanchez
Member
lego brick.. works better than coins
MattThomMakesMeWarmInside
Silver Member
coins slide out. If the spring rattles because it isn't snug, take it off, and keep squeezing it a little bit together with vice grips until it fits snug. Keep testing it. Also, buy a 1/4 GRADE 8 3 inch bolt with a NYLOC nut. File or drill out the hole where the brake spring goes until the 1/4 bolt snugly fits in both sides. Also do with the same to the brake. Put it together and tighten it hard. Actually really easy.
ashz893scootys
Member
the best way to make ur brake solid is to use no spring works so well
swiftsbasher
Member
ash do u just go on and try to piss people off
G McCaffrey
Member
bearing with hot glue will hold up for a while. but i drilled some holes in my ultra pro and put on a tsi flexfender and im so much happier with it now. bigggg improvement