How to raw vertx t bars?

[Austin Forkner]

I have a pair of black vertx t bars and I put a lot of stickers on and the a took them off and the sticks took some paint off and it looks bad. I have different bats for my regular scooter but I want to put the t bars on my dirt scooter. So should I raw my bars? If so how do I do it and will it look good?

 

[issac p]

Omg. Look at the thread under this, and use search next time.

 

[Robert]

Set them in a bathtub full of water for 24 hours.

 

[Austin Forkner]

Well I went to wipe the sticky stuff off the back of a sticker off my bars using gas and the paint on them just came right off!! Vertx must use cheap paint?! But anyway I decided to either just put a clear coat over the bars and run them raw or paint them. What should I do? Is it hard to paint bars?

 

[issac p]

dude, post this in the "how to raw parts" thread
and its not that hard to paint parts. just read the directions on the can and make sure you dont get too close to what you're painting.

 

[Kyle B.]

they will look nice i got my raw vertx ts yesterday and they look nice but worng section