i need help with getting my pro clamp on my buffs

[blaise825]

the regular clamp is shitr so im trying to put on my pro camp but i cant stretch it far enough to fit any advice on how you guys got it to work if so?

 

[aj_rides_scoots]

allen key. thts what i did with jeremys buffs

 

[blaine142]

dude, take two big flat headed screw drivers and take the screws out of the clamp then put the screwdrivers in the the clamp so that they are crossing like x's and each screwdriver is toughin oppisite sides, then bend it out put it on the buffs. the if its too big put the flat side of the clamp put it on the anvil part of vice and then take a hammer and hit it and u can see it when it gets square then put the bolts in ur done.,

 

[codyferner]

all i do is get a fat chisel and beat it into the clamp and then slip it on with the chisel in the clamp.
its easy

 

[!Iscoot369]

sand down the inside of the clamp so it fits like it fits on a stock razor pro and just tighten the clamp like u normally would

 

[Mike Montgomery]

screw the two nuts in back wards and put a penny in blocking them from threading through the second side. tighten it and it stretches the clamp, slide it on, take out the screws, and screw them in the right way.

 

[blaise825]

sand down the inside of the clamp so it fits like it fits on a stock razor pro and just tighten the clamp like u normally would

that would require a redicules amount of sanding..... and i did the penny thing except with a quater worked wonderfully

 

[Mike Montgomery]

i tried sanding it down and it took forever and didnt work. then i used a dremel tool and that didnt work. then i used the penny thing