inward forks

[Mark Abramsky]

if a get a threaded one i wont have to do the compression set right
?

 

[JonnyJonDogg]

not on threaded

 

[natethegreat]

marks its nate get them threadless and deal with the headset im getting the same ones.. and andrew is. but yea if its threaded you dont need it

 

[MattThomMakesMeWarmInside]

marks its nate get them threadless and deal with the headset im getting the same ones.. and andrew is. but yea if its threaded you dont need it

no dude really just get them threaded. its actually in the end cheaper and wayyyy easier and better. It wont break even though its threaded. Not with these forks

 

[Mark Abramsky]

yea i bend fork not brack em so idc if its threded and i dont wanna deal with the compression

 

[MattThomMakesMeWarmInside]

yea i bend fork not brack em so idc if its threded and i dont wanna deal with the compression

yeah compression is gay so just get threaded and never worry about it again.

 

[matthew]

oh dear, forks break at the threads, and realy how hard is it to use a compression system.

 

[Jdbug_rob]

yeah, but these forks wont break at the threads cos you can get them soooo thick!

 

[matthew]

realy how thick

 

[MattThomMakesMeWarmInside]

3mm.... thats thick

 

[ilovethetruth]

and if your as insequre as i am and want to make sure they last forever....

YOU CAN REINFORCE THEM (.120) WITH STOCK HANDELBAR THINGS (WERE THE GRIPS GO) ALL YOU NEED IS ONE OF THOSE AND 1 AND ONLY 1 LAYER OF MASKING TAPE PUT IT ON THE BAR (ONLY ONE LAYER!) AND HAMMER IT IN

 

[matthew]

holy shininagwaldbrida thats proper tank. i might invest, rob how much is it for one bought and shipped to uk in 3mm?