Lucky Wheels

[MaxAmillion]

I dont know if I am the only one with this problem, but it seems I really need a lot of power to put bearings into my Lucky wheels. I got the bolth all the way in except in is very lightly crooked. And both of the bearings spin like crap. I even greasea the inside of the core and it was still hard to put them in. Im doing the trick with a bolt and two bearings on each end. I also needed to hammer a little to get the bearings in antiny bit more. Can somebody help me? Have any of you had this problem with Lucky/other wheels? I know its hard to put bearings in metal cores but it is really hard for me to get them into lucky wheels.

 

[yoyoflavored]

Try putting them in and tightening your axle like crazy, this works for me to even out the pressure of the bearing spacer... otherwise take them out then press them in with a bolt and washers.

 

[christianewing]

I dont know if I am the only one with this problem, but it seems I really need a lot of power to put bearings into my Lucky wheels. I got the bolth all the way in except in is very lightly crooked. And both of the bearings spin like crap. I even greasea the inside of the core and it was still hard to put them in. Im doing the trick with a bolt and two bearings on each end. I also needed to hammer a little to get the bearings in antiny bit more. Can somebody help me? Have any of you had this problem with Lucky/other wheels? I know its hard to put bearings in metal cores but it is really hard for me to get them into lucky wheels.

I know thats the only trick there really is to put bearings in at your house but its one of the most shittiest things you can do. If you can go to a bmx shop or anywhere with a press just press them in.