metalcore bearings

[volcom32388]

impossible to get out once they are in there or what?

 

[Roycee]

Ummm,
I couldnt get mine out without breaking them.
I used a centre punch and a hammer and hammered them out.
But i didnt use a spacer in the middle of the wheel.
Wait till someone like Madis or Brian Boston posts something, they will know what to do.

 

[Zack Jackson]

mine were really hard to get in but now i cant get em out.. so yea all i use usually is an allen key

 

[D= its sam!!]

get a alan-key n put it through 1 bearing so its touchin the other then hammer it out

 

[volcom32388]

yeah i just dont want to crack the metal and have the bearing be loose forever after that, but i have some brand new swiss bearings that i wanna get in there

 

[skinner]

i got a small thin metal rod put it through and hammered it out

 

[qwxor]

lol just ride them till they ovalize, then they'll pop out on their own then do whatever you need to do. then put tape on them or however you fix the ovalizing and ride them again yay

 

[volcom32388]

i got em out hammered em from the backside got the nice freshies on them now rolls like butta

 

[scooterpro]

lol the metal doesnt crack hahahahah use a bolt it works the best

 

[dre]

If you have enough money to buy metal cores, then you certainly have enough money to buy some new bearings..

 

[skylerforreal]

Yeah I agree with Dre

 

[Dylan Kasson]

make sure the spacer in between the 2 bearings isnt aligned and then puta axle through it and start hammering
since its pretty much pounding it straight out it shouldnt be hard to do at all metalcores are tricky, but if you get the bearings exactly right putting them in and out they slide out really easy

 

[Brian Boston]

If you have enough money to buy metal cores, then you certainly have enough money to buy some new bearings..

What if i saved all my money up for a pair of metal cores, now i dont have any money for bearings Hah

 

[D= its sam!!]

metal cores only cost me like 35 euros (51 dollars) i feel sorry for u guys in usa haha

 

[AJ]

damn you sam!! lol

 

[SharkStammler]

because we have to pay for the huge shipping expenses

 

[Andy Rhode]

if you have a spacer in the middle of the bearings you get that not centered so if you hit that it wont go through but it will hit the bearing and keep hammering that and in a minute or two it will get your bearing out. thats what i did today

 

[Dustin Nooner]

make sure the spacer in between the 2 bearings isnt aligned and then puta axle through it and start hammering
since its pretty much pounding it straight out it shouldnt be hard to do at all metalcores are tricky, but if you get the bearings exactly right putting them in and out they slide out really easy

 

[WayFastRevo]

http://www.youtube.com/watch?v=7II9n_TD3Zc

ha my voice was soo high piched

 

[volcom32388]

yeah yeah yeah i know how to take bearings out i skateboarded for 6 years and scootered for 2 i was just sayin metalcores are alot tighter.... but there out its all g .... end of thread