MFX AFFRAY - Please Help!

readybmxer

Bronze member
I was wondering if anyone knows how the fork is threaded. Of course, not the outside of the steerer tube, but the threads for the compression bolt. Is it a small, screw-like thread, or is it a large thread running around the inside diameter of the fork? It's an IHC fork which utilized the HIC system for oversized bars, very specific to MADD Gear models, so it uses a large compression bolt, one that threads on the inside diameter of the fork.

Will it fit in the same way that the stock steel forks will fit? No modifications needed to get it working?

Thanks!
 

Elliott SR

Bronze member
I was wondering if anyone knows how the fork is threaded. Of course, not the outside of the steerer tube, but the threads for the compression bolt. Is it a small, screw-like thread, or is it a large thread running around the inside diameter of the fork? It's an IHC fork which utilized the HIC system for oversized bars, very specific to MADD Gear models, so it uses a large compression bolt, one that threads on the inside diameter of the fork.

Will it fit in the same way that the stock steel forks will fit? No modifications needed to get it working?

Thanks!
Yeah. Ever worked with HIC? Just that but smaller. Trust me, with nearly no knowledge of scooters, I disassembled IHC and put it back together. That was two years ago. It's easy stuff.
 

readybmxer

Bronze member
Yeah. Ever worked with HIC? Just that but smaller. Trust me, with nearly no knowledge of scooters, I disassembled IHC and put it back together. That was two years ago. It's easy stuff.

Okay, thanks a bunch, dude!

Yes, I began on a Phase Two Radke Dirt Scoot, one that uses HIC. I definitely realized how similar the two were when I disassembled the IHC for my MADD Gear recently.

Thanks again!
 
Top