MGP deck spacers for back wheel?

[Harryboy300]

I lost the spacers on my madd gear pro, so now my back wheel shakes back and forth. and im tryin to get new ones...

Anyone know a good size, and where i could buy them? I lost one of the spacers, and it sucks having a shakey wheel.

 

[parrish]

just go to a local hardware store you can probably find one there

 

[Michael Rankin]

Contact Madd and see if they will send you a new one.

 

[Harryboy300]

Contact Madd and see if they will send you a new one.

i was thinking about that, but im from california.

 

[Michael Rankin]

Doesn't matter. My friend got a replacement deck from them and he is from san diego.

 

[Harryboy300]

Doesn't matter. My friend got a replacement deck from them and he is from san diego.

ohhh. well thanks.

 

[Michael Rankin]

Yep, give it a try

 

[Harryboy300]

but hey, do you know where i can contact them other than the madd gear website?

 

[aussiechriz]

us aussie just use old bearings, just hit it with a hammer, until it breaks open and use the middle bit, fit just great

 

[Harryboy300]

us aussie just use old bearings, just hit it with a hammer, until it breaks open and use the middle bit, fit just great

I didn't think about that... thank you.

 

[ktmfmx]

us aussie just use old bearings, just hit it with a hammer, until it breaks open and use the middle bit, fit just great

Grrr i was just about to say that.

or you get some m8 nuts and drill the thread out with a 8mm bit i did dat wen i didnt have any spare bearings

 

[Billie Rainbow]

us aussie just use old bearings, just hit it with a hammer, until it breaks open and use the middle bit, fit just great

i reccomend this instead of the actual spacers. also put one of those tiny spacers that come with skateboard bearings if you can fit it in.

 

[jordyskoots]

just get a pro spacer and grind it down

 

[Billie Rainbow]

thats a waste, using old bearings is better

 

[MaTt.OnE]

haha good old aussies always coming up with awsome ideas

 

[tarrymonz]

yeah i just used a screwdriver and a hammer to hammer out the balls in the bearings
then used the inner race as a spacer

 

[J SWEETS]

local hardware store i just got tiny washerss.