MGP pegs wont fit MGP Ninja?

[EthannW]

k so i bought some mgp pegs from skatehut
http://www.skatehut.co.uk/acatalog/MGP_Aluminium_Stunt_Pegs__pair.html
and they dont fit on my ninja forks! on the front of the forks where the bolt goes in ,it sorta..pops out ?
heres a pic

the area inside the red .. shape i drew is extruded,and when i put the peg on its on a tilt. it also wont fit on the back as they are too big in diameter. any help? oh and to file down the back on this it would mean cutting the top third of the peg off. any help on this? im also wondering if the 81 customs pegs
http://www.rawk.com/product/81-customs-grind-pegs/2340/
or the blazer canista pegs
http://www.rawk.com/product/blazer-canista-alloy-scooter-pegs-pair-new/2531/

would fit it?

 

[EthannW]

anyone know?

 

[skope]

use spacers..YOu can use the one that goes between the bearings, but then the peg would stick out a lot.

 

[R-Dubya]

Seriously. Just put a small washer or two between the fork and the peg. It isn't that hard to figure out.

 

[Billie Rainbow]

a spring washer is about perfect to fill the gap