[moved] Berings

smith101

Member
hi I today am triying to take out my berings on a razor A scooter but how
do you do it without dameging the baring? Do you just pound on it with a hammer until it comes out or what?
<span class='smallblacktext'>[ Edited ]</span>
 

dreads3213

Bronze member
i'm going to try and approach this vague question...
if you're referring to the wheels then you can either take an allen wrench and carefully pry the bearings out from the inside or if the middle spacer moves around then you can just take the bolt that you unscrewed to take off the wheel and push on the spacer when it is now aligned and it will force the bearing out the other side. no hammers needed unless the bearings are rusted in which case they are useless.
if you're referring to the bearings in the head then you're crazy
 

Brian Boston

I got myself banned.
take an allen key, put it in the hole and pry it out, if it wont budge spray windex on it and let it sit for a minute then try, windex will loosen it up
 
umm i think if u have like a rod i use a skate board truck like the trucks of it and do what the skateboarders do...if u didnt get it off by now
 
If you can get bearings out of a skateboard wheel easily everytime then you can get a bearing out of anything because its a bitch pulling them out good..shew it sucks
 

brandon kilbury

Super Moderator
skateboard wheels are so easy to get bearings out of if you have a truck..just put the bearing on the axle and pry it off..
 

james

Member
or use a screwdriver and a hammer and smack one end if its not coming out.
<span class='smallblacktext'>[ Edited Wed Jul 20 2005, 06:41AM ]</span>
 

Brian Boston

I got myself banned.
if your into messing up the sheilds on the bearings

spray windex on, take allen key, put in hole, lift, bearing is out
 
Top