Need2Put grips on, riding tomorrow.

dowdie223

Bronze member
im riding tomorrow and i need to know a way to put on grips that will dry by 2mmrw. i feel like ill have throttle grip if i use wd40. any other methods?
 

Sam_Hudson

Bronze member
hairspray or an air compressor. with hairspray just spray a LITTLE bit on your bars and grips and they should slide on. with an air compressor get the grip on a little bit then spray air inbettween the grip and bars while pushing and twisting
 

dowdie223

Bronze member
hairspray or an air compressor. with hairspray just spray a LITTLE bit on your bars and grips and they should slide on. with an air compressor get the grip on a little bit then spray air inbettween the grip and bars while pushing and twisting

i dont have an air compressor , i wish. but yeah ill try hairspray, thanks.
 

scootrz r gaey

Bronze member
i just put a little water in the grip, then like rape them until they are snug on my bar. works evreytime with no throttle at all, you just have to use a little force
 

Juan.

Silver Member
I use veggie oil. Put some on a napkin then put it on the bars and then pass the napkin through the inside of the grips. Dries 5-30 minutes if done right.
 

dpnelson31

Steel Member
Hairspray, alcohol, or spray paint work best. They all dry within a few minutes, hairspray taking the longest.
 
1. Wrap electrical tape around yours bars where you're going to put your grips on.
2. Loosen up grips by putting them in boiling water for about 30 seconds
3. Hairspray the hell out of the inside on the grip and the bars
4. Muscle it on there, there will never be throttle once it dries

(if drying must be done extremely fast, boiling water step may be skipped, but it helps the grips loosen up so they can be formed on the bar, then shrink again)
 

Rob.

Admin
Staff member
Spray adhesive is best.

MainImage.jpg
 
Top