Origin headset

Lance

Member
when i had mine i had to tighten it so tight to be solid and it would not spin for shit and id loosen it up a bit and it would wobble
 

Smack

Member
I love the Origin8 headsets. All headsets are precision pieces and you have to be careful with them. The bearings should fit in perfectly, if you are having to tap them in or press them in you probably have them at an angle. Take them back out and try to put them back in straight. Same thing with the cups, when you start bangin on the cups with hammers you are just asking for trouble. It's a pain in the ass to install an FSA crown race on most forks, but the Origin8 is split so it sets on there perfectly. To set your cups, take your time and use a vice with a couple of pieces of wood and you should be ok. Remember, a hammer is not a precision instrument.
 
Top