Phoenix Switchblade fit French I.D

[JayWatt]

Just asking you guys before buying this will a Phoenix Switchblade fit French I.D deck? Keep in mind the Frid only has one whole in the deck and i would prefer not to alter the deck other than counter-syncing the whole bigger so it will fit a 5mm bolt.

 

[Can]

Yes.

 

[JayWatt]

Sweet any modifications needed?

 

[michaelpytel]

if you can do it right, the easiest modification woudl be to bend the sides of the brake bit, the like square part that goes into the deck, bend the sides up so that they fit snug into the frid deck, you knwo what i mean?

 

[Trace]

no it doesnt fit

 

[michaelpytel]

no it doesnt fit

yes it does. its a little small because of the extra cut for the french id break, but with common sense the break will work fine.

 

[Trace]

yes it does. its a little small because of the extra cut for the french id break, but with common sense the break will work fine.

no-

 

[michaelpytel]

no-

why not. why do you say it doesnt.?

 

[michaelpytel]

i just went to my basement and took my wheel and brake out, so i could put in my phoenix brake to show you it works because iv done it before, but then i realized i sold all the phoenix brakes i had so never mind. but iv done it before and it works fine. so i feel like you have little to no basis on the fact that your saying it doesn't work.

 

[nick silverman]

i have a frid and a pheonix brake its fits

 

[michaelpytel]

i have a frid and a pheonix brake its fits

exactly. thanks. idk why this other kids saying it wont work.

 

[nick silverman]

exactly. thanks. idk why this other kids saying it wont work.

yeahe dont worry if you want both holes youll have to drill the second one witch isnthard and you dont have to do

 

[Dewey]

this doesnt have to do with the brake but when i tried puttin my wheel in with the stock back wheel spacers and it didnt fit at all, so all morning i spent looking for bearing and wheel spacers that would fit