proto gripper problem

[jeremy carr]

i have a black proto gripper and i tighten it fully so theres no wobble in the wheel. then 5 mins later after riding the wheels wobbling i was told to switch out the bearing spacer i did then 5 mins later again i have to to switch out again to make it stop wobbling does any one no how to fix this nor do they have this problem?

 

[jeremy carr]

11 views but no replys shows what happened to sr.

 

[jeremy carr]

come on people

 

[DJ Lee]

i had a paragraph for u but i got logged out

 

[Zach!]

myn were like those the place were you put the bearings is too big for your bearing put tape around your bearings and you should be good

 

[J.hildebrand]

id say get a good strong bolt and se locktite

 

[DJ Lee]

ok instead of changing out spacers, u might need to adjust one to fit. the bearing spacer razor gives u is a bit too long "just by a little" so just hammer it a little bit shorter. but unless u have a micrometer,, ull have to do it by trial and error. but if that doesnt work ur bearing race is ovalized. tape around the bearing will fix that..
and if That wont work. pm me i got more ideas

 

[Michael Rankin]

You would probably get more answers if you posted in the right section.