proto help

S

salamiiscooter

Member
i jsut bought 2 110mm protos..
yea i kno im stupid but i didnt think bout it..
i have a ultra pro deck\
weni put the wheel on, it rubs on the brake spring
i grinded it down but it didnt work..

is there any way of putting it on so it doesnt rub on the brake????
 
mattttyler

mattttyler

Bronze member
ya dude idk if this will work for you but put an allen in your brake axle and turn it
it might make the brake go up and down idk thats what it did for me it took me like 6 hours to figure that out
just turn the axle till its at its highest, and then try
youll have like 1mm of space but it works fine i like it now i dont like brakes where you have to push it a down mile to start braking
 
FIVEO

FIVEO

Member
Rσb said:
Hey dillweed this thread isn't about eagles. take that somewhere else.
I dunno though, I rode two protos fine on my ultra pro..
Click to expand...

same thing here.. I put 2 brand new 110 proto on my kids ultra pro and it worked fine...Worst case take a plier and pull up on the end of the brake
 
M

matr!

Silver Member
Yeah but that takes forever and it's a waste of time really when you could just instantly fix it by shoving something under the brake...
 
nitroRCs

nitroRCs

Member
Guys. He said it rubbed on the brake SPRING. Not the brake itself.

Either, your brake bolt is bent, or there is something weirdly wrong with it. Maybe also, if your brake bolt isnt bent, try taking your sprin off, turning it around and putting it on the other way.
 
V

vantagerider

Member
same exact problem with me. ultra pros are retarded they only fit 100 mms and if your fork is the least bit bent it wont fit on the front. best advice is to just run it on the front for a while till its 100mm then switch it to the back and put the other one on front
 
You must log in or register to reply here.
Top