Proto SCS problem

[TH3 SC00T3R DUD3]

When I took out my first 3 bolts they smelled burnt and when I Tried to take out my last bolt it wouldnt budge I even put all my weight on the allen key and it would not move. I think its jammed...what should I do?

 

[AliAnderson]

Stop...... HAMMER TIME. Get a drill and powerdrill dat shit off.

 

[Maz.]

You have to take the bolts out at the same time, not one by one or they'll get stuck,

 

[TH3 SC00T3R DUD3]

Stop...... HAMMER TIME. Get a drill and powerdrill dat shit off.

I dont have a power drill, I've heard cutting it works but how would u do it?

 

[NickSeymour]

yu do the same as when yu are tightening them up, quarter turns for each bolt so it doesnt put maximum stress on one of the bolts

 

[gjdadj]

put the bolts back in and tighten them HARD then remove the siezed one. if you remove the tension it should just twist out like a norm bolt

 

[yoyoflavored]

put the other three bolts back in to equalish tightness, then loosen them by quarter turns until they are all loose enough to twist out with your fingers. when your done drip some 3 in 1 oil down the threading and on the bolts.

 

[gjdadj]

^^^^ this