Proto SCS shim

[Tobin]

switching from oversized to standard bars and i dont have a shim so is there somewhere i can buy one or make one somehow? as i need it for my bars plz reply i nee to know asap

 

[issac p]

i think you can use a piece of oversized tubing.

 

[AndyNguyen]

i think you can use a piece of oversized tubing.

Yup this works

 

[Michael Osterlund]

pop can shim

 

[Tobin]

i think you can use a piece of oversized tubing.

so whatever the dimensions of oversized bars are i go to like home depot and get tubing and just cut a line through it? can anybody give me further instructions on how to do it?

 

[Tobin]

pop can shim

lol

 

[Foster]

Here ya go
http://www.skyhighscooters.com/ProductDetails.asp?ProductCode=00-02-05
And they have them on freestyle depot but they are out of stock plus they cost more.

 

[Tobin]

Here ya go
http://www.skyhighscooters.com/ProductDetails.asp?ProductCode=00-02-05
And they have them on freestyle depot but they are out of stock plus they cost more.

thanks man

 

[Tobin]

is there a way to make one though? like actually a how to or could you just tell me because i dont want to wait for the shim

 

[Broccoli1]

so whatever the dimensions of oversized bars are i go to like home depot and get tubing and just cut a line through it? can anybody give me further instructions on how to do it?

Doubt you'll find the correct size tubing at Home Depot and the Tubing at Home depot is not the correct material anyway- it has a seam on the inside of the tubing because it is actually a flat pice of metal rolled into a Tube and then welded, the outside seam is then ground off.

If you do use a piece of ERW Tubing then just cut the slit at the welded seam.

I noticed you are in Toronto, look up Metal Supply places and try there. If they are cool they might sell you just a short piece of 4130 or even aluminum tubing.