Proto sliders Rawing problem

[Conner.]

So I rawed my proto sliders and put my bearings in. Now everytime they hit the ground on its side it makes this annoying clinking noise. Has anyone else ever had this problem and know how to fix it?

 

[Conner.]

Bbb

 

[Alex Collins.]

Rawed mine and never had the problem, perhaps they are ovalized? Remove the bearing and hammer the wheel around the bearing slot about 4 times then re-install the bearings.

 

[issac p]

If you left the bearings in when you rawed the wheels, you probably messed up the lubrication in the bearings. Re-lube them and you should be good.

 

[toddpickel]

Rawing wheels leaves them to ovalize much easier than they should, look up on YouTube, "How to un-Ovalize Wheels" or something along those lines, that should help ya out.

 

[Dallen.]

I told you they would ovalize. Lol

 

[Conner.]

I hammered them a lot and they still make that noise, but the bearings are still hard to hit out.

 

[Conner.]

So i hammered the shit out of them and the bearings were super hard to get in, but they still make that weird noise when my tire hits the ground sideways. My scoot is still dialed and the bearings are soooo hard to get out.

 

[Skips]

So i hammered the shit out of them and the bearings were super hard to get in, but they still make that weird noise when my tire hits the ground sideways. My scoot is still dialed and the bearings are soooo hard to get out.

My friends scooter does that evo though it's dialed . It's the spacers clinking against the wheel for him. If not try a new set of bearings?