protos

[Dom Marconi]

ok if i spin my proto it looks mega wobbly like a bent bike wheel.
and my friend has the exactly same thing.
is this happening to any of your wheels?
its probably not a major problem but?

 

[humpurple kushiones]

yea. it happens to my plastic cores. i think its how you put the bearings in

 

[Lil Steve]

Your bearings are in straight. Try hitting them in with a rubber mallet.

 

[demo]

it might be just the urthane. cause buff said there was a problem with the adheasive to the core

 

[TUC]

Your bearings are in straight. Try hitting them in with a rubber mallet.

no if you hit them in like that they will often go in crooked thus causing them to wobble. what you should do is make a bearing compressor out of a bolt and some washers and just use that to put them in.

 

[the_SD_local]

it might be just the urthane. cause buff said there was a problem with the adheasive to the core

The urethane would not make the core wobble.

Your bearings are not in all the way and/or they are not in straight. You have to PRESS them in evenly in a vice, arbor, hydraulic press or with a bolt and some washers (as a last resort). You need to install them ONE at a time also. If you try to put them both in at the same time you are pretty much guaranteed to put them in crooked.

 

[demo]

i thought he ment like the urthane made it look like it was core was wobbleing.

 

[Dom Marconi]

mine just slide in without a bearing press, almost as easy as plastic cores

 

[demo]

well it is not outstreched.

 

[Humma]

Happened to my bro today with a stock wheel.
turned out his bearings were broken.

 

[Dom Marconi]

mine arent