Seatpost Bars & SCS

[Tanner!]

Hey guys,
I have an SCS and one pieces but I was wondering if I could make seatpost bars compatible with an SCS. The reason i want to do this is so i can find the right height and width for the next bars I buy. How could i make a stock sheath fit in an SCS?

Post your ideas.
Thanks in advance,

-Tanner!

EDIT: W00T 1000TH POST!

 

[KieranPeterson]

Cut the slit off them? Exactly 2 inches off the bottom (no homo).

 

[Tanner!]

Cut the slit off them? Exactly 2 inches off the bottom (no homo).

Yeah I know, but wouldnt the steer-tube's OD be too small to fit w/o wiggling?

 

[Michael Rankin]

make a shim for it

 

[Tanner!]

make a shim for it

It would have to be a thick shim, I just checked and it would have to be a really thick shim... I'll make one later.

 

[Mark Abramsky]

use a fuzion nx steertube

 

[Jacob D.]

I think that if u cut off the slit it will be the same OD and ID as normal one pieces, I would check for you with my half knuck and my old razor steerer tube, but I have ICS and it would be a pain in the ass

 

[Remco]

just put a piece of forktube (2" long) in the bars. So the slits wont bend when you tighten your SCS. That way you wont have to make any shims to make it fit.

Correct me if I'm wrong.

 

[Tanner!]

just put a piece of forktube (2" long) in the bars. So the slits wont bend when you tighten your SCS. That way you wont have to make any shims to make it fit.

Correct me if I'm wrong.

yeah i know what you mean but the diameter at the bottom is bigger than that at the top, and on the bottom there isnt 2 inches of the same diameter cuz it shrinks.

 

[Jacob D.]

yeah i know what you mean but the diameter at the bottom is bigger than that at the top, and on the bottom there isnt 2 inches of the same diameter cuz it shrinks.

exactly what i was thinking

 

[anticee23]

just put a piece of forktube (2" long) in the bars. So the slits wont bend when you tighten your SCS. That way you wont have to make any shims to make it fit.

Correct me if I'm wrong.

nah nah your right

 

[Tanner!]

nah nah your right

read my post ^^...

 

[Remco]

put a piece of 1/2" of some old bars underneeth the bars you're gonna use. That way it has anough clamping surface, and its smooth with the part where your bars are tapered.