When I put the rear wheel bolt into my tsi, it goes in at an angle even with all the spacers on properly. The wheel in turn is at an angle and touches the side of the frame... can someone please help me with this problem... I reallyyyyyy dont want to send it back because then i have to wait like another month for a new one
Tsi help please
- Thread starter mcnutty93
- Start date
darknessanbu
phillip[take-3]
for the wheel u gotta but 1 washer on each side of the wheel. this way it doesnt tocuh the frame. so just put one on one sideit works .
my friend tsi was having the same problem and we fixed it like that
my friend tsi was having the same problem and we fixed it like that
Kevin Lo
Bronze member
Yah, me and him did this. We put 2 skinny washer next to the bearings so the sides dont touch. So its like you put a razor axle on, the short ones, and you put a spacer on the other side were it will touch the bearings. Shove the wheel on and slide the other spacer in the opposite side. and tighten em. If your confused ill try to make a video.
there yahh go shane..... send that tsi right back and get a new 1