your custom/homemade parts thread
- Thread starter ashz893scootys
- Start date
Nicksandman
Bronze member
I.want.these.Heres some bars I made. 20 X 23 Hic tapered on bottom. Like 3 degrees of backsweep. Sooo hard to get them even on both sides lol.
I might be able to get better pics later.
Garrett B
Steel Member
Haha, they are like the most comfortable bars Iv'e ever ridden. Because they dont have too much backsweep. And their lighter than Rads. Oh, and I cut out a rectangle piece in the crossbar so they look a little like Addict's hahaa
Chadders55
Member
Polished up SZ Clamp
What polish did you use?!
It takes a couple steps:
Sanding off the Anodizing using different Grit until you get a shine on the Metal then move over to a Buffer to get Final mirror finish using a Polishing Compound.
I have a pretty decent bench mounted belt sander that allows me to change the sanding belts quickly so I can do this whole process in about 15-20 mins.
MT362-100-Bundle, Multitool 8" Grinder Bundle
http://www.vansantent.com/multitool.htm#thumb
The Buffer/Polisher I use is just a regular Bench grinder with a Buffing wheel mounted on it instead of a Grinding wheel.
Sanding off the Anodizing using different Grit until you get a shine on the Metal then move over to a Buffer to get Final mirror finish using a Polishing Compound.
I have a pretty decent bench mounted belt sander that allows me to change the sanding belts quickly so I can do this whole process in about 15-20 mins.
MT362-100-Bundle, Multitool 8" Grinder Bundle
http://www.vansantent.com/multitool.htm#thumb
The Buffer/Polisher I use is just a regular Bench grinder with a Buffing wheel mounted on it instead of a Grinding wheel.
BrandonWeir
Steel Member
This whole thread is filled with cranky people and shitty jokes.
Robert Reichley
Bronze member
Hic bars.
Now these, i would buy.. Very sturdy construction.. You should make some with backsweep too
Sam_Hudson
Bronze member
For sale, freshly made
some prototype backsweep with gussets.
would you trade other bars for a pair
