Brian Boston
I got myself banned.
How are those wheels?
YOUR SCOOTER #3
- Thread starter Madis
- Start date
- Status
josh gummersall
Member
i dig em...fast, ive only rode SB for like 2 hours tho so i havent put a ton of stress on them. it was either thems or the mach 2's and i chose these because the urethane or whatever was harder
scooterpro
Member
lol fuk man when i saw it on the ground i couldnt stop laughing because yur stem was curved
Alex von Schroeter
Member
lol
sweet scoot
sweet scoot
farmboy uk
Steel Member
nice looking scoot
ryans scoot sucks, that is all
ryans scoot sucks, that is all
D= its sam!!
Ex-Staff
hey guys iv finished ma scooter (i think) lol
here it is :
abec 9 bones bearings.
stock wheels.
full deck tape.
locked foldy.
front n bak pegs. 7 bearings at front, 4 bearings and spacer at the bak.
reinforsed fork.
here it is :
abec 9 bones bearings.
stock wheels.
full deck tape.
locked foldy.
front n bak pegs. 7 bearings at front, 4 bearings and spacer at the bak.
reinforsed fork.
josh gummersall
Member
im pretty sure i know the concept for the forks...cory was gonna make the same kind but never got to it
you place a star nut thing in the rad bars far enough up, place over fork, and you get a long bolt that goes from the bottom of the fork just over the wheel that reachers to the star nut and tighten that to adjust compression on the headset...then just clamp your clamps and get ready to race
you place a star nut thing in the rad bars far enough up, place over fork, and you get a long bolt that goes from the bottom of the fork just over the wheel that reachers to the star nut and tighten that to adjust compression on the headset...then just clamp your clamps and get ready to race
gorrilaman
Member
Hooray. I got like 10 bolts for pegs. 13 cm long , 8mm thick. Its not threaded all the way so my front wheel have a peaceful ride. I wanted to put 8 bearings each but then the back axel was too short for 8. I probably will use 5.
- Status