YOUR SCOOTER

DMazz

Steel Member
IMG_9992.jpg

Specs:
Matt Mckeen bars
ODI grips
district light double clamp
Envy IHC fork
dual Envy 5 spoke wheels
district v2i with envy integrated headset
 

DMazz

Steel Member
I do, it's just above the bottom of the fork a bit. It sits above about a half inch. I had to cut the shim down on the IHC shim due to the bolt snapping half way into my forks, so I'm using a half compression bolt, and 3/4 of a full shim.
 

DMazz

Steel Member
Envy forks got a piece of there forks that don't allow them to go down any lower, or I'm using a wrong one. Either way it worked out perfect hahaha scoot is soliddd
 
you're starting something back up thats already over with.

See man, you're doing it again. I don't judge, nor am I biased, I think you're a decent dude and I'm telling you for own well-being on this site. I think you should be treated just as equal as everyone else, but you can't piss people off. I'm not starting anything back up my dude, given the history of it, you might easily do that in the future because it has happened more than once. I'd be starting something up if it was already settled and then I ruffled through it again. Trust me, I'm on your side.
 

Travis House

Wu-Tang Master
Staff member
Next person that posts anything but a picture of a scooter or a comment about a scooter gets a infraction. Come on folks, this is basic.


That burgundy addict is an art piece. You paint it yourself dude?
 
Top