district bars HELP

joker44

joker44

Member
ok so i just got a district headset and bars for my RUP v2 so headsets on do i have to put any of those threaded bolts back on and my bars wont stay on like i cant get them tight do i use the shim?
 
BenJelinek

BenJelinek

Administrator
Staff member
Lolwut? Are u talking about the bolts in your clamp? Hahaha yeah u need those tight as hell hahahah
 
BenJelinek

BenJelinek

Administrator
Staff member
Well do your bars have a cut at the bottom of them? Your forks are threaded right? You need to tighten the bolts as tight as you can.
 
Creative

Creative

Steel Member
one you need an oversized clamp, two what kinda forks are you using; if your using stock rup ones than yes you do need the nut in top of the nut.
 
Creative

Creative

Steel Member
bearings upside down maybe? idk im stumpedd, loosen the headset alittle. or just get threadless forks and scs.
 
Creative

Creative

Steel Member
take everything apart and take a video of you putting it back together, and i ahd my volume up wicked high cause your wicked quite and then lil wayne came on and it was like s
shaking my deskk. :b
 
brody01134

brody01134

Steel Member
yeah same :p the only thing i could think of is the bearings in upside down, abut i cant think if why ur forks are twisting
 
S

Scooterhero1

Member
did you check the bearing do the spin ok when they are not in the cups if not contact district or try fliping the bearing around
 
You must log in or register to reply here.
Top