chromoly handlebar

[ScootingFred]

Will the chromoly handle bars that you can buy for the buffs fit in my stock t-tube?, and then just drill holes. I'd assume they would fit, and this is probably a dumb question, but i want to be 100% sure before placing any orders.

 

[jeff26]

yes, but you will need to sand the inside of your ttube to get it to go in. stock razor bars are a little smaller than 7/8. so it wont just slide in. it will take some work. tape sandpaper on a drill bit and just sand the inside of the ttube.

 

[scooterkid101]

no the buff bar pole is 7/8 and it wont fit in stock bars u need to get 3/4 thats what i have and its still a tight fit

 

[gil_]

i asked buff the same thing and he said when he tried it he had to snad A LOT of it down for it to fit but its better just to go to home depot find the right size pipe (3/4 works fine) and then bolt it =]

 

[jeff26]

if you used 3/4 wouldnt your grips slide of really easy? idk, ive used 7/8 the times ive used

 

[dre]

if you used 3/4 wouldnt your grips slide of really easy? idk, ive used 7/8 the times ive used

same.. plus, sanding down the inside of your t-tube only takes about 30 minutes max.

 

[jeff26]

it didnt take me too long at all. howd you do it? i put sandpaper on a drill bit. took like 10 minutes.

 

[Eric Magray]

yous gotta be careful what your talking about. pipe uses relevant measurements which are completely different from the actual dimensions; 3/4" pipe is bigger than 3/4" OD tubing.

but sorry im not exactly sure how well a buff chromo tube will fit in a razor t-tube.

 

[ScootingFred]

i asked buff the same thing and he said when he tried it he had to snad A LOT of it down for it to fit but its better just to go to home depot find the right size pipe (3/4 works fine) and then bolt it =]

yea I did that, bolted it and evrything, and they snapped the first day, plus handlebars slipping off every trick.

 

[gil_]

i asked buff the same thing and he said when he tried it he had to snad A LOT of it down for it to fit but its better just to go to home depot find the right size pipe (3/4 works fine) and then bolt it =]

yea I did that, bolted it and evrything, and they snapped the first day, plus handlebars slipping off every trick.

yeah my grips would slide off to

 

[skavenger]

Put duck tape or masking tape over the grip area to give it more thickness.

 

[ScootingFred]

it didnt take me too long at all. howd you do it? i put sandpaper on a drill bit. took like 10 minutes.

ok, but how hard is to drill through to make holes for bolts?, is it like aluminum?

 

[jeff26]

yea, but we are talking about sanding the inside of the ttube, drilling and bolting isnt hard. the hard part is getting the pipe to fit.

 

[chrisisme]

try sanding then hammer the pipe in. you might not even have to bolt it. Or just get a seatpost.

 

[Eric Magray]

im sure hes got it handled by now. there was no reason to bump this thread.