how to make homemade grind plates?

[NateShewell]

Any one know how?????

 

[NateShewell]

FUCK wrong forum.... can some one move it

 

[chrisisme]

it's in scooters. Uh no idea

 

[Eric Magray]

grind rails i think are made of hard urethane. since its slick. idk how you plan on molding your own urethane. unless you mean like a metal grindplate. then i guess you could just get some metal, countersink the screws into the deck and there ya go.

 

[yamamsmells]

if its a b or a pro i guess, get a box section of 2 x 1.8 , so 2 up and 1.8 across then just get some longer axle bolts and your set.

 

[blaine142]

grind rails suck they rattle all the time idk about grind plates but i dod know htat grind rails suck

 

[Steezeman]

I made one once out of a cutting board, just cut it to the right size and countersink the bolts and it'll be good. It might mess up your clearance a bit but it's really slick.

 

[Eric Magray]

hmmm, i like that idea. im about to head up to dollar tree and get me a cutting board today and try that.

 

[Steezeman]

Be careful if you're using high speed tools to cut the cutting board, because it gets really hot/melty and will burn you really bad. I know from experience.

 

[zakmak]

haha im just going to get a pair of grind rails and see how good these are.

anyone know like the best place to get them for cheap?

 

[bball4will]

http://www.a1skateboards.com/
the price on almost everything is cheaper comparing to other sites.

 

[Eric Magray]

Be careful if you're using high speed tools to cut the cutting board, because it gets really hot/melty and will burn you really bad. I know from experience.

haha ok. ill see if i can find some gloves somewhere.