RAD prototype forks
- Thread starter Stanio
- Start date
JonnyJonDogg
Member
coz they look different?
humpurple kushiones
Steel Member
ehh. they look stronger then stock but ummm... well if you can just put gussets there and make the edges smooth, i think they will look kickass
Tommy Napolitan
Errrhhmmmm
thye look like you could bend the legs
corruptedrapture
Member
those look so sickk
devinthedew
Member
ya weld gussets on the back and it would look rad lol
redline582
Member
I think they look pretty good, but definately grind down those sharp edges on the front of that top plate bit.
Chris Harris
Chris Harris
when will they be available
Legs are ovalized and they are cut that way in order to get them in as close to the wheel as possible so they are almost right under the steer tube. Making it harder for the top plate to bend. The legs are really thick and stiff front to back, I dont think they will need a gusset.
scootsteve
Member
JonDogg said:
just 2 i think and a seperate head tube of one of them
Is that a compression system on top of that forks?coryM said:
Legs are ovalized and they are cut that way in order to get them in as close to the wheel as possible so they are almost right under the steer tube. Making it harder for the top plate to bend. The legs are really thick and stiff front to back, I dont think they will need a gusset.
And a integrated head set?
That forks look better from this angle.
jojofoshow
Member
they almost look like inwards
natethegreat
Member
that compression looks pretty sick and the other head tube. anyway the forks are pretty sweet i like em at keast (idk how much that counts but o well) just dk about how they are cut on the opposite side
Tommy Napolitan
Errrhhmmmm
that compression system is sooooo simple