The Hillbombing Thread.
- Thread starter RiccardoM
- Start date
microdownunder
Bronze member
I pretty much only bomb hills. (I don't have the co-ordination for tricks)
I use a micro Speed+, 145mm wheels mean I don't have to worry so much about debris and a bigger brake means it's a bit easier to slow down if I need to. Could maybe do with some wider bars for stability.
I use a micro Speed+, 145mm wheels mean I don't have to worry so much about debris and a bigger brake means it's a bit easier to slow down if I need to. Could maybe do with some wider bars for stability.
jay_pauling
Member
This was pretty much my hill bomber
jay_pauling
Member
I used it for flatland kinda stuff as well, fuck using a scooter for only one type of riding
Kevin Booth
Bronze member
its so funny seeing these scooters.
ChrisBrown
Steel Member
This was pretty much my hill bomber
So legit
Billie Rainbow
Silver Member
Addict deck, forks+ti axle, brake, headset cap and brake
Mgp 2 piece down tube with mtb bars 26.5h 24.5 wide, 7 back and 3 upsweep
Proto Slider
WeThePeople rhombus grips
Tilt scs
3.4kgs
was built for this but serves normal riding just as good
morgan_bvrns
Steel Member
+1000 points for the GoPro
PhilScoots
Member
bars are about 30 inches wide haha ^^
RiccardoM
Steel Member
Just a design of a long scooter deck I'm designing. The orange bits are going to be open ended and will work a little like a jet - it'll take the air in and force it out the back through a smaller hole even faster. D'you reckon it'd work? 6" by 27". 
I think there could be a bit of work done around the back where the neck tunnel joins on to the others.
Honestly, I'm not sure it would make a difference but what are your opinions?
I think there could be a bit of work done around the back where the neck tunnel joins on to the others.
Honestly, I'm not sure it would make a difference but what are your opinions?